I left the sensors and wire on the dpf pipe and used some large heat shrink folded one end and sealed the ends with heat.
Slided the opened end over the sensor plug on the truck then lightly heated them up and then used a nylon tie to secure them, that way hopefully crap won`t get in and mess up the connections.
Good Luck !
2007.5 GMC Sierra 3500 SRW "BLACK", SLT, C.C., 4X4, Loaded, DMax,Z71 Edge Insight CTS2, PCV Re-Route , Sinister EGR Delete, AirDog, ISSPRO fuel pressure gauge, BD Manifold, Diamond Eye down pipe & front pipe, 5" DPF(less)back exhaust with 6" tip, DIY Stock airbox mod with aFe Proguard 7 airfilter, Cognito NON Torsion Bar 4" lift, Cognito UCA's, Pitman/Idler arm support, Sulastic Rubber Shackles, Firestone Ride Rite, Bilsteins 5100's front/rear EFILive ECM tuned by ATP www.atptrucks.com TCM tuned by www.duramaxtuner.com 2007 GMC Yukon Denali "BLACK" 6.2 gasser
LUCAS Fuel Treatment and LUCAS Oil Stabilizer
DIY stock AirBox Mod, K&N, Airaid intake, EFILive TCM only by MJE Tuning
Last edited by D_R_C; 03-29-2015 at 02:27 PM.