| I dunno if you still waiting for a answer on this... but i have the service manual right here and for that code it states:
Conditions for setting the DTC
The SDM detects the steering wheel module deployment loop resistance is greater than 4.8 ohms for 500 milliseconds.
The SDM detects the voltage at the steering wheel module high signal is less than 2.4 volts and steering wheel module high to steering wheel module low signal resistance is 6 ohms or greater for 500 milliseconds
Diagnostic Aids;
A short between the steering wheel module high and steering wheel module low signal circuits.
A malfunctioning shorting bar on the steering wheel module connector
A malfunctioning shorting bar on the steering wheel module coil connector..
Hope this helps |