| EGT Gause install ?
OK I have an 05 CC DRW I my gauges will be here Friday and I hope too get them installed friday night. I am getting the isspro boost and egt gauges on the pillar mount. future plans are a PPE exellerator programmer my Question is where too put the egt sending unit? I really want it pre turbo of coarse but I don't want to pull the turbo to make sure I don't leave any metal shavings. So if I go with post turbo what sould I look for in the way of egt temps. I know 1400 is safe for pre turbo.
1 So is pulling the turbo on this truck a bad Ideal?
2 If yes, then what about post turbo for the sending unit?
3 what have some of you done that works?
The truck has just over 36,ooo on it and I use it for pullin a 34ft gooseneck weighing in at around 14,000 pounds. give or take a few thousand!! |