[TORCH]

Originally Posted by RedBowTies88

hmmmm.... 404 shouldn't cause a limp if i remember right...

OK I got the stick installed last night!!!! So far so good! drove to work today with no codes. (this has not happened since the EGR blocker install) Codes that were throw are as follows, 401, 404 and 101.
401 and 101 had no affect on the truck other than the CEL. when the 404 showed up it would act as though there was no tune on it. went fine. just very sluggish. no rpm limit, no 3rd gear lock. Just acted weak. only could get 15 psi out of the boost, EGRs were way down as well. Once the code 404 was cleared it would go right back to normal. just FYI, I was under the assumption when I installed the blocker that I would not have any issues, as that is why I made my own plate instead of purchasing both plate and stick at the same time. I just wanted othere to be aware