Edge Programmer Made My Truck Stall

[Redneck17]

I was down the Outer Banks this morning on my way home and my truck stalled twice going to take off from a red light. I had the tune in 3 (drive), had been driving for over an hour, it was almost 100 degrees outside at the time. The first time it stalled i was able to get it started and into a parking lot. I disconnected it, let it sit for a few minutes, and the hooked it back up. went to leave and it stalled again. I then disconnected it again and drove 400 miles home with no further problems. This is the warmest weather I have have ever driven in with the Edge, the AC was running. On the way down my monitor went out and I shut the truck off, wiggled all the wires, and it worked again.

What causes the truck the stall like this? Should I leave the chip out? The check engine light came on, but went off.

Thanks

[Redneck17]

bump.........

[deeretracks]

You need to check the pins in the plugs and make sure that there are not any that are pulled out to far or or lose or bent.

[tommy469]

call edge and there going ot tell you to send it to them bcuz thats what mine is doing also