| Hey boomer glad to hear the install went smoothly for you, like you said if you just take your time it's no sweat. Hoov on your truck there is a blue intercooler tube on the passenger side of the engine that connects to a metal intake tube that goes to the engine intake. This metal tube is where you could tap for the boost gauge. It should have one or two other sensors on it but there should be room for you to tap for a fitting there. Just disconnect the blue tube and stick a shop vac into the metal tube to catch metal shavings while you drill and tap.
__________________ 05' Dmax LLY CC SB, 6in. Fabtech with Heavy duty tie rods,
35in. MICKEY ATZ's, 20in. KMC's,
6000K HID headlights & fogs,
PPE Hot Xcelerator, 4in straight exhaust, Afe stage II intake, Resonator block-off,
PPE boost controller, aeroforce scan gauge
Killerbee Compressor Mouthpiece
PCV reroute courtesy of Tony Burkhard All Seasons Service
Upcoming mods: Lift pumps, Fully built tranny
On the Way: PPE intake manifold w/EGR delete  | 
Linear Mode
