Chevy and GMC Duramax Diesel Forum banner

Edge monitor

1K views 6 replies 6 participants last post by  shadow747 
#1 ·
Can yall post pics of the different places you mount your edge monitors on an lly?
 
#4 ·
Lol someone made another one less than a week ago that i responded to already


-head studs and gaskets
-66mm
-5” straight pipe axle dumped
-shimmed
-full s&b intake and mouthpiece
-dans diesel 800 HP built trans with biller stator
-dans built trans tunes
-glowshift EGT, boost, fuel pressure(have not found a sender to work for it yet), edge cts2
-Cognito built tie rods
-fuel lab 100 gph lift pump
 
#6 ·
This is where I put mine, nothing special but it makes it easier to remove each time I park my truck somewhere. I don't like leaving it visible.

I ran the cord down the side behind the plastic panel. I can send more pics if you'd like. But it came out really clean I think.


Sent from my SM-G965U1 using Tapatalk
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top