If possible,will take a lot work. For starters donít expect the electrics to be anything near close. Hence building pigtails. Secondly, seriously doubt that the seat mounts are even close to what you have. Therefore requiring some sort of mount plate to make everything bolt to the truck.
I know the electronics wont be the same at all, and i know the rear mounts are no where near the same, but i figure the fronts would require redrilling holes and making new connections for the power functions. Other then that the center console would be the biggest issue since i know the whole interior wont swap over being as the cabs are smaller in these older trucks.
2002 LB7, leveled, Kryptonite Tie Rods and Upper Control Arms, 20x10 Hostile Sprockets, 295/55/20s, s&b intake, 5Ē Flo Pro exhaust, 3.5Ē turbo horn, FASS 165, Insight CTS2, EFI Live ran off CTS2 by GDP tunning