I've searched up and down on here and haven't found anything. But how in the hell are you suppose to tighten the bottom bolt on the horn with just a hex key? Anyone have any tips?
Yup I have everything out of the way per instructions on the Pro Fab paper that came with it. Pulling the stock one out was a breeze and installing this one was too up until tightening the bottom bolt. Just wondering if there were any tips or tricks anyone has used. The ball head would more than likely work, but I don't have them.
Putting my bolt in and the darn bolt broke half threaded in and the head fell off.... Now what?! Will ProFab send me a new one? I wasnt reefing on it at all.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Chevy and GMC Duramax Diesel Forum
3.8M posts
207K members
Since 2005
A forum community dedicated to Chevy and GMC Duramax diesel owners and enthusiasts. Come join the discussion about modifications, towing, classifieds, troubleshooting, maintenance, and more!