Chevy and GMC Duramax Diesel Forum - View Profile: Ron Nielson

Ron Nielson Ron Nielson is offline

DuramaxForum Veteran

  Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. Kdcarmack@gmail.com
    10-06-2018 08:02 PM - permalink
    [email protected]
    Been having problem for last 6 months. It does have the dpf deleted and i have a programmer for that and also have an edge programmer for fuel economy. I run it on 5 for driving around town and stock or 0 when pulling a trailer. So I drove the truck last Saturday pulling a 32’ dove tail loaded with skid steer (total weight 15,000 lbs) went in limp mode 7 times in 50 miles was able to clear code with edge, and same on trip back home. Usually goes in limp mode around 50 mph under heavy loads. Truck sit over night and went out to start it and would not start. Tried pumping filter housing while cranking truck still no start. Talked to Chevy duramax mech and he said sounds like either pressure reg or injector pump was out. Ordered injector pump and installed, replaced fuel and air filters with ac delco filters and truck started. Truck feels like it has more power and more pick-up. Pulled trailer loaded with lumber and pallet of concreate and again went into limp mode around 50mph.

  About Me

  • About Ron Nielson
    Location
    Berryton, KS
  • Signature
    Ron Nielson
    2008 Silverado LT, CCLB, Edge Insight CTS
    2009 Arctic Fox 29-5T, Silver Fox Edition, Onan 3600 LPG generator

  Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: Yesterday 09:54 PM
  • Join Date: 08-13-2009
  • Referrals: 0

  Mentions

No results to display...

  Quotes

02-28-2020
06:06 PM - Ron Nielson quoted Fireman07LBZ in post P0340 after engine rebuild, crank no start.
Ron, I checked my grounds again a...
06:00 PM - Ron Nielson quoted Fireman07LBZ in post P0340 after engine rebuild, crank no start.
I have wiring diagrams, just need...
02-27-2020
03:21 PM - JimmyD quoted Ron Nielson in post 2010 lmm good deal
I THINK that's a pretty good pri...
11:00 AM - Chachie quoted Ron Nielson in post F*#@ing "SERVICE TRAILER BRAKE SYTEM"
It is ABSOLUTELY FRUSTRATING to ...
02-25-2020
01:32 PM - KaliMax quoted Ron Nielson in post Stranded in La Grange KY
For sure you're going to need go...
02-07-2020
08:39 PM - bellassaiw10 quoted Ron Nielson in post Radio Engine Feedback
I figured a dedicated ground wou...
12:08 PM - dukeboyty quoted Ron Nielson in post Egr delete vs DPF delete
If you have someone who can do t...
11:59 AM - Ron Nielson quoted bellassaiw10 in post Radio Engine Feedback
I figured a dedicated ground woul...
11:29 AM - dukeboyty quoted Ron Nielson in post Egr delete vs DPF delete
If you have someone who can do t...
11:22 AM - Ron Nielson quoted dukeboyty in post Egr delete vs DPF delete
Between a EGR and a DPF delete...
02-05-2020
02:36 PM - skierz quoted Ron Nielson in post help please: emissions test set off CEL P0098 intake air temp sensor 2 circuit high
Check the circuits before decidi...
02:34 PM - skierz quoted Ron Nielson in post help please: emissions test set off CEL P0098 intake air temp sensor 2 circuit high
Check the circuits before decidi...
01-30-2020
06:27 PM - Ron Nielson quoted Len Todd in post Ads Make this Site Unstable
With all the darned ads, this...
01-29-2020
10:36 PM - Allwhitelb7 quoted Ron Nielson in post 06 LBZ code P0756 SS "stuck off" HELP NEEDED BADLY!!
One quick determination could be...
01-28-2020
02:28 PM - Ron Nielson quoted bellassaiw10 in post Bilstein 5100's too soft
I replaced my bump stops and noti...
01-27-2020
10:14 AM - Ron Nielson quoted chamuco in post Pass Lock light on dash
delete
10:11 AM - Ron Nielson quoted cincykid in post 2015 sierra 3500 HD trailer brake relay
Need to find a trailer brake ...
01-26-2020
08:25 PM - Ron Nielson quoted jbell1033 in post "Check Trailer Wiring" Warning Message
We also have “check trailer wi...
01-19-2020
01:24 PM - Ross07lbz quoted Ron Nielson in post Wait to start light takes a long time to go out
When I'm starting my truck, I pu...
01-17-2020
06:01 AM - deez112 quoted Ron Nielson in post Rpo code dpn
DPN Mirrors, outside heated pow...

  Likes Received

124 Likes
  1. onetigger725
    onetigger725 liked post by Ron Nielson On thread : Getting screwed by a restoration shop
  2. 407driver
    407driver liked post by Ron Nielson On thread : Getting screwed by a restoration shop
  3. Nitro Junkie
    Nitro Junkie liked post by Ron Nielson On thread : Getting screwed by a restoration shop
  4. onetigger725
    onetigger725 liked post by Ron Nielson On thread : Oil in coolant after repair
    Yes, back to the dealer for sure. You paid for a 1st class job and deserve one also.
    Liked On: 02-09-2020, 11:32 PM
    Posted On: 02-09-2020, 04:23 PM
  5. Allwhitelb7
    Allwhitelb7 liked post by Ron Nielson On thread : 06 LBZ code P0756 SS "stuck off" HELP NEEDED BADLY!!
  6. 407driver
  7. 407driver
    407driver liked post by Ron Nielson On thread : Injector balances all the same
  8. Hook'em_Horns!
    Hook'em_Horns! liked post by Ron Nielson On thread : Another gremlin, jump in with suggestions.
  9. 407driver
    407driver liked post by Ron Nielson On thread : Another gremlin, jump in with suggestions.
  10. Mafrici
    Mafrici liked post by Ron Nielson On thread : Duramax electrical problems. Please help
  11. Nitro Junkie
    Nitro Junkie liked post by Ron Nielson On thread : Belt Tensioner & Idler Pulley Bolts
  12. onetigger725
    onetigger725 liked post by Ron Nielson On thread : Dual Batteries - How does it work?
    Wiring diagrams are available at GMUPFITTER.COM - no cost.
    Liked On: 01-08-2020, 09:19 PM
    Posted On: 12-13-2019, 02:56 PM
  13. Fredn3ck
    Fredn3ck liked post by Ron Nielson On thread : P2771 & p0700 help asap
    1048775
    Liked On: 01-07-2020, 04:16 AM
    Posted On: 12-07-2019, 11:11 AM
  14. UTEngineer
    UTEngineer liked post by Ron Nielson On thread : Is Precise Fluid Level in Differentials Required ?
  15. Dales Super Store
 
For the best viewing experience please update your browser to Google Chrome