Chevy and GMC Duramax Diesel Forum - View Profile: Ron Nielson

Ron Nielson Ron Nielson is online now

DuramaxForum Veteran

  Visitor Messages

Showing Visitor Messages 1 to 1 of 1
    10-06-2018 08:02 PM - permalink
    [email protected]
    Been having problem for last 6 months. It does have the dpf deleted and i have a programmer for that and also have an edge programmer for fuel economy. I run it on 5 for driving around town and stock or 0 when pulling a trailer. So I drove the truck last Saturday pulling a 32’ dove tail loaded with skid steer (total weight 15,000 lbs) went in limp mode 7 times in 50 miles was able to clear code with edge, and same on trip back home. Usually goes in limp mode around 50 mph under heavy loads. Truck sit over night and went out to start it and would not start. Tried pumping filter housing while cranking truck still no start. Talked to Chevy duramax mech and he said sounds like either pressure reg or injector pump was out. Ordered injector pump and installed, replaced fuel and air filters with ac delco filters and truck started. Truck feels like it has more power and more pick-up. Pulled trailer loaded with lumber and pallet of concreate and again went into limp mode around 50mph.

  About Me

  • About Ron Nielson
    Berryton, KS
  • Signature
    Ron Nielson
    2008 Silverado LT, CCLB, Edge Insight CTS
    2009 Arctic Fox 29-5T, Silver Fox Edition, Onan 3600 LPG generator


Total Posts
Visitor Messages
General Information
  • Last Activity: Today 12:03 PM
  • Current Activity: Viewing Thread Trailer lights flickering
  • Join Date: 08-13-2009
  • Referrals: 0


No results to display...


05:26 PM - redwngr quoted Ron Nielson in post 2014 lml p0420 code
Has your truck gone thru the reg...
11:04 AM - Henshman quoted Ron Nielson in post
09:11 AM - Ron Nielson quoted rknuesel in post High temps in the hills
Eng bumping 240 and then Tran...
01:53 PM - dmaxmonkey quoted Ron Nielson in post 2009 trailer brake relay connector
Use your VIN# and do a parts loo...
09:25 AM - Ron Nielson quoted Joelmichelle1 in post Support bearing?
I have a 2001 chevy Silverado 2500...
06:43 PM - Ball Man quoted Ron Nielson in post MBRP 4" Exhaust installation issue. i can't see a solution here...
For SURE, MBRP needs to do a muc...
07:16 PM - hebigchief quoted Ron Nielson in post Rpo zk3
[quote=Ron Nielson;12225919]ZK3...delux...
03:57 PM - D7revs quoted Ron Nielson in post ECMRPV Fuse keeps blowing
I believe there have been report...
02:11 PM - D7revs quoted Ron Nielson in post ECMRPV Fuse keeps blowing
I believe there have been report...
11:52 AM - ShopSpecialties quoted Ron Nielson in post Kennedy Lift Pump?
I, for one, would prefer to have...
11:43 AM - Ron Nielson quoted ShopSpecialties in post Kennedy Lift Pump?
With the Kennedy unit being a centri...
07:11 PM - Redneck Dave quoted Ron Nielson in post Egr delete question
Rob very well may have turned of...
06:58 AM - Redneck Dave quoted Ron Nielson in post Black Market Performance "lift pump"
I have no specific information, ...
11:39 AM - Ron Nielson quoted Denali2012HD in post Questions regarding factory brake controller?
I've moved out to a higher altitu...
10:26 AM - yooper327 quoted Ron Nielson in post New Idler Bracket Tight to Turn
You are aware that turning the s...
09:09 PM - Ron Nielson quoted quartermaster in post Rear ABS or Rear End
. The ABS tone rings are at the si...
06:59 PM - Ron Nielson quoted jakep4401 in post Shake?
Would that cause the truck to ...
06:34 PM - jakep4401 quoted Ron Nielson in post Shake?
At 160K miles, you are likely in...
08:13 PM - Ron Nielson quoted alan01 in post Overdrive Off and Tow mode
2005 gmc 4500. Should I tur...
10:51 AM - Ron Nielson quoted Jeff11 in post Dextron VI - AC Delco 10-9395 or 88861954
I had seen the article that...
For the best viewing experience please update your browser to Google Chrome