I have a 2007.5 LMM. It has 110k miles. It's pushing 40's.
In the winter when it gets bellow about 29 degrees, On cold starts the transmission is always stuck in 3rd gear. It won't go into reverse or anything. I have to let the truck warm up then turn the truck off for about 5 minutes and then the transmission runs fantastic. It gives me anywhere from 5-12 engine codes every time it does it.
I have always been able to clear the codes after the issue.
A few days ago it got into the lower 20's and the trans spilled out about a half quart of fluid onto my driveway overnight (Never leaked before). I started it up and let it warm up, Turned it off for 5 minutes and it drove fine however I wasn't able to delete all the CEL lights. I can clear the codes and not even start the truck and the codes are there again.
truck didn't leak at all after that night until last night when it dropped into the 20's again and it did the same thing. Leaked a good amount onto the driveway, started and ran great after warm up but I still can't get the codes to clear.
Here are the codes that I can't seem to clear-
P0700
p0877
p0694
p0761
p0756
p0751
I drive like an old man, The trans doesn't slip, Doesn't and has not gone into limp mode.
I feel like the fluid has to be freezing?? Any suggestions?
Thanks in Advance.
Jason
In the winter when it gets bellow about 29 degrees, On cold starts the transmission is always stuck in 3rd gear. It won't go into reverse or anything. I have to let the truck warm up then turn the truck off for about 5 minutes and then the transmission runs fantastic. It gives me anywhere from 5-12 engine codes every time it does it.
I have always been able to clear the codes after the issue.
A few days ago it got into the lower 20's and the trans spilled out about a half quart of fluid onto my driveway overnight (Never leaked before). I started it up and let it warm up, Turned it off for 5 minutes and it drove fine however I wasn't able to delete all the CEL lights. I can clear the codes and not even start the truck and the codes are there again.
truck didn't leak at all after that night until last night when it dropped into the 20's again and it did the same thing. Leaked a good amount onto the driveway, started and ran great after warm up but I still can't get the codes to clear.
Here are the codes that I can't seem to clear-
P0700
p0877
p0694
p0761
p0756
p0751
I drive like an old man, The trans doesn't slip, Doesn't and has not gone into limp mode.
I feel like the fluid has to be freezing?? Any suggestions?
Thanks in Advance.
Jason