[steve+zeus]

been starting hard. had to prime. newair+fuel filter 2wks ago stock truck . less then 1k then plowed snow for 6 hrs. tried tostart ,started 2nd try shut off ,tried to start again 3x pumped primer,thenstarted ,shut off let run 1hr ,shut off , tried to start 1hr later, nogo

 

[1953drtelco]

Are you showing any error codes?

 

[VulcanD3]

Sounds pretty much like what my truck was doing last month... Read my thread. It was injectors.

http://www.duramaxforum.com/forum/01-04-5-lb7-duramax-powertrain/45623-cranks-but-wont-start.html

 

[steve+zeus]

triy a bunch things,goingtocheck chafed wire,o-rings ,fuel in oil tomorrow and also showing about 20 codes

 

[mijdirtyjeep]

Not trying to be a D**K, but if you could retype your post in proper English it would help:drink

 

[steve+zeus]

sorry,i am tired. just want to get truck running

 

[mijdirtyjeep]

sorry,i am tired. just want to get truck running

I hear ya about being tired.

When you cracked the bleeder, was there air in it? Also has all this started since the fuel filter change?

 

[steve+zeus]

the fuel was only 3k

 

[mijdirtyjeep]

the fuel started it

Well then, I would start by making sure the WIF sensor "on the bottom is tight. Next do a visual and make sure there is no leaks anywhere. If that checks out, pull the filter to see if for some reason one of the O-rings did not seal right. While you have the filter off, pull the WIF off and do a real good visual to make sure you did not over tighten it and crack it. It just sounds like you have an air leak, and need to locate it.

 

[steve+zeus]

thank you i will try tomorrow and let you know.