Chevy and GMC Duramax Diesel Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey everyone.
I've kinda hit a bump in the road hear.
I blew a shock on my truck and I think I've settled on Bilstein 5100 or 5160 as the replacement.
I know the truck is lifted or leveled but I'm not sure how much. I measured the block under the rear leafs and they measure 2" so I'd assume a 2" lift in the rear. However I can't figure out the front. The bottom shock mount is clearly extended and measures 3.5" I belive stock is 1" so im thinking 2.5" in the front. My thought is that the extended bracket allows a stock shock to be used even tho its lifted 2.5" but I'm not sure.
If someone could clarify or correct me if I'm wrong that would be greatly appreciated.
Pics attached
Automotive tire Gesture Wood Art Tire

Tire Wheel Vehicle Automotive tire Motor vehicle
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top