Chevy and GMC Duramax Diesel Forum banner
  • Hey Everyone! Enter your ride HERE to be a part of this months Ride of the Month Challenge!
1 - 2 of 2 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
Bought an autocal and Efi live from ppei and when I go to tune my truck I get a $0A05 error code when I hit read tune on my autocal. Tried calling PPEI a bunch and and sent an email but I need my truck tuned for some truck pulls in a few days. The truck apparently has a 25hp flash from when I got it if that’s causing the issue I’m facing. Couldn’t find any write ups about it
 

·
Registered
Joined
·
10,692 Posts
It's a controller configuration issue. Either on your end or theirs, I'd guess theirs since you most likely bought a pre loaded autocal. You need to configure the autocal to read the correct ecm in efi live v8 it will be f5 bbx settings then select the lly ecm.
 
  • Like
Reactions: Stroked06Goat
1 - 2 of 2 Posts
Top