Chevy and GMC Duramax Diesel Forum banner
  • Hey Everyone! Enter your ride HERE to be a part of this months Ride of the Month Challenge!
1 - 6 of 6 Posts

·
Registered
Joined
·
1,849 Posts
Discussion Starter · #1 ·
I put mine on this past weekend, and when tightening the U bolts, before the bottom nut reached 40 ft.lbs. the plates bent in some, the directions say it's normal, but my driver side bent in quite a bit, wondering if the bottom part of everyone elses side plates are bent in, and how much? Thanks.
 

·
Registered
Joined
·
106 Posts
Both of mine are bent in probably .5" on both trucks. Both installed by a dealer. Right or wrong theres been no problems and the 03s been installed for 6 years.
 

·
Registered
Joined
·
1,849 Posts
Discussion Starter · #3 ·
Thanks for the quick feed back, I guess mine is alright then.
 

·
Registered
Joined
·
599 Posts
Yup, mine put in by the top local guys and they are bent too, you're all good. Congrats on the B&W, you'll love it
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top