Chevy and GMC Duramax Diesel Forum banner
  • Hey Everyone! Enter your ride HERE to be a part of this months Ride of the Month Challenge!
1 - 2 of 2 Posts

·
Registered
Joined
·
244 Posts
Discussion Starter · #1 ·
how do you bleed the fuel lines after replacing head gaskets?
 

·
Registered
Joined
·
5,569 Posts
Open the bleeder and pump until fuel comes out. Then try and fire the truck. It most likely will not fire, just do not crank for more than 20sec's. Next go back and pull the bleeder again and pump till fuel comes out clean "No bubbles". Keep repeating until it fires.

A buddy of mine opens his bleeder and uses a shop vac to to pressurize the system and push fuel through the bleeder. That would also work.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top