Chevy and GMC Duramax Diesel Forum banner

1 - 8 of 8 Posts

·
Jack of all trades.......
Joined
·
98 Posts
Discussion Starter #1
newb or just dumb question, If ive already put the dsp5 version in my ecu, do i have to full flash it again if i change something or can i just do the calibration flash? I've been doing the full flash with no problems, just trying to load it faster than 10 min.
 

·
Quicker Then Brian!
Joined
·
11,080 Posts
lb7's are funny i think theres a quirk to them about this...i know lly+ is just a calibration flash

if you look in the dsp5 tutorial it should tell you for sure
 

·
Slave to the Interwebs
Joined
·
9,953 Posts
I think i read where it is just a calibration flash on all of them. I know the LBZ and LMM are just calibration flashes
 

·
Registered
Joined
·
2,320 Posts
Copied from EFI forum;

LB7 = Full Flash to change any DSP1-4 tables, even after the initial DSP5 conversion is done

LLY = Full flash to DSP5 OS, then Cal flash for any other changes for main tables or DSP1-4

LBZ/LMM = Full flash to DSP5, then Cal flash for any other changes to any of the tables
 

·
Oh...... Squirrel!
Joined
·
24,083 Posts

·
Oh...... Squirrel!
Joined
·
24,083 Posts
1 - 8 of 8 Posts
Top