Chevy and GMC Duramax Diesel Forum banner
  • Hey Everyone! Enter your ride HERE to be a part of this months Ride of the Month Challenge!
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I just got my autocal in last night and trying to get it loaded in the truck but just keep coming up with error codes. I would like to call ppei but its the weekend and their closed. Anybody got some advice other than be patient and wait till Monday to call? The codes i am getting are.... 0333 0331 0311... I have tried numerous times and actually got it to read the stock tune all the way till about 23% before it says please wait and turn ignition off.
 

·
Registered
Joined
·
2,430 Posts
Have you updated to the latest firmware?
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
No I haven't . To be honest im not too sure what you mean by it lol. Im brand new to all of this... I have got it to read out the factory but when I move on to flash the tunes it doesn't have the "full 1 dsp5" it has e54_003.ctz up to 0016 so at a loss for info again...
 

·
Registered
Joined
·
2,430 Posts
You should probably just give them a call
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top