Chevy and GMC Duramax Diesel Forum banner
Cancel

Help with boost tube and gauges

1738 Views 12 Replies 4 Participants Last post by  kweber1911, 
duramax07tmd
I did a search and could not find anything. Could someone please explain where i need to drill and tap for the boost tube on my LBZ. I got some new gauges and just got my pillar painted this week. So i would like to get them installed as soon as possible. Also where is the best place for the power, ground and illumination wires?

If anyone has any pictures that would be very helpful.

Thanks in advance!
Reply
Save
Like
1 - 6 of 13 Posts
duramax07tmd
That is perfect! Thank you. Now does it really matter if it is drilled and tapped on the top, side or bottom?
Reply
Save
Like
duramax07tmd
Also, is there a trick to get the boost tube to stay snug into the fittings so it wont pull out?
Reply
Save
Like
duramax07tmd
I gave you a call yesterday Trey, check your messages. So just hand tightening wont get it snug enough? Because thats all i have done so far just messing around with the parts. I have not installed them yet.
Reply
Save
Like
duramax07tmd
where else to you suggest tapping it?
Reply
Save
Like
duramax07tmd
Its all good, my V2 and DSP5 should be here tomorrow and im off work tuesday so i plan to install everything tuesday.
Reply
Save
Like
1 - 6 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Chevy and GMC Duramax Diesel Forum
A forum community dedicated to Chevy and GMC Duramax diesel owners and enthusiasts. Come join the discussion about modifications, towing, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Discussion 01-04.5 LB7 Duramax Powertrain Introductions Exterior Build Threads
Top