Chevy and GMC Duramax Diesel Forum banner

Get high or go Fast? 2015 ideas...?

  • Relift the LML with bigger wheels and tires + Cp3 Conversion

    Votes: 15 14.3%
  • Twins/Cp3 Conversion/Built trans from SDP

    Votes: 91 86.7%

  • Total voters
    105
  • Poll closed .
14281 - 14300 of 15477 Posts

·
Finally! Wheels on!
Joined
·
9,072 Posts
They don't look bad. They just look a lot like every thing else out there
 

·
Most Known Unknown
Joined
·
29,473 Posts
Discussion Starter #14,283
Just looking at wheels that would look good with a lowering kit

If I went 22x10 without paying an arm and a leg it would probably be a Hostile Exile

hostile_h105_24x14-1411-071-00-1000.jpg
 

·
Registered
Joined
·
18,025 Posts
Just looking at wheels that would look good with a lowering kit

If I went 22x10 without paying an arm and a leg it would probably be a Hostile Exile

View attachment 807634
I like those jdub. Clean and simple and are a nice looking wheel.

Sent from my VS985 4G using Tapatalk
 

·
Registered
Joined
·
1,526 Posts
I think both choices would look good w/the exiles being more unique.
 

·
Registered
Joined
·
1,521 Posts
I like the hostile wheels much better
 

·
Most Known Unknown
Joined
·
29,473 Posts
Discussion Starter #14,287 (Edited)
I have to agree on the Hostiles

With the width and offset they would play nicer IF the truck was lowered allowing for a slightly bigger tire

But at the same time the fuel wheel with its wider width and 1mm less offset....it would only stick .47" out more than the Hostile

When the time comes it'll depend on how much room I'll have on the bumper side

If guys can run 12s with large fender mods and 305/45s then I should have more wiggle room with ELF fenders

And another thing....I've always had FUEL wheels so it would be hard to swap brands...

But that Exile wheel is, pretty slick n simple :help
 

·
Most Known Unknown
Joined
·
29,473 Posts

·
Most Known Unknown
Joined
·
29,473 Posts
Discussion Starter #14,290
I think the 22x10 -25 would be the better choice

Here is smokeastroke's truck with 20x10 -24, on 285/55 terras

Which I like ALOT over my setup and his is stock height, which if the truck was 2-3" lower up front it would look even coooooooooler!

All photo rights go to smokeastroke:

PhotoEditor-1457280079918.jpg

PhotoEditor-1457280117405.jpg
 

·
Registered
Joined
·
46 Posts
I need to raise the front an inch and a half to make it level haha.
 

·
Most Known Unknown
Joined
·
29,473 Posts
Discussion Starter #14,292
No way man looks good the way it is!

Here's a front end swapped LMM with 20x10 -21 AE wheels

If I go with the 22x11 fuel lethal they would stick .5 out more than yours smokeastroke

And would be 1.30" tucked in vs running a -44 12" wide wheel

All depends on the drop

10801980_10203228096479638_3688449460953178651_n.jpg
 

·
Registered
Joined
·
46 Posts
I think you need the hostile wheels...
 

·
Registered
Joined
·
5,884 Posts
The flag pole in the receiver is totally badass. :grin2:
 

·
Most Known Unknown
Joined
·
29,473 Posts

·
Premium Member
Joined
·
1,459 Posts
Looks good JW
 

·
Most Known Unknown
Joined
·
29,473 Posts

·
Most Known Unknown
Joined
·
29,473 Posts
Discussion Starter #14,298
Sooooo

My birthday is in a week

The wife said she got me something that's on order (3 weeks) and that we will have to go to the DMV for this county

Wtf does that mean?!

I'm afraid
 

·
Finally! Wheels on!
Joined
·
9,072 Posts
Divorce?

Probably personalized plates. "MACDDY", RATROD, WHIPPD

we know REDNECK is taken....
 

·
Registered
Joined
·
5,035 Posts
Ya I was gonna say personal plates too. Wife is getting some for her Acadia.
 
14281 - 14300 of 15477 Posts
Top