Chevy and GMC Duramax Diesel Forum banner
  • Hey Everyone! Enter your ride HERE to be a part of this months Ride of the Month Challenge!
1 - 2 of 2 Posts

·
Registered
Joined
·
4,411 Posts
I would personally say consult a local shop and have a steel unit made. Should be pretty cheap.

Kinda hoping newtomegmc chimes in as it's his area of expertise and has helped quite a bit of us better understand the dynamics of what to do and not do when it comes to drive shafts.
 

·
Registered
Joined
·
4,411 Posts
Steel is the way to go if cost is of any factor to you... lol
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top