Chevy and GMC Duramax Diesel Forum banner
  • Hey Everyone! Enter your ride HERE to be a part of this months Ride of the Month Challenge!
1 - 2 of 2 Posts

·
Registered
Joined
·
195 Posts
Discussion Starter · #1 ·
Next week she goes in for the lift, finally! Cognito 4-6 ntbd, AF 20x10's and
Toyo M/T 35 x 12.50s. I was thinking about adding the bushwhacker boss flares too but my question is this. This setup requires some small trimming when set around 5 inches in the front. Are mods required on the boss fender flares as well and what does that look like?

Once she's done I'll post pics. Can't wait!
 

·
Registered
Joined
·
195 Posts
Discussion Starter · #4 ·
If you do a fender mod you have to cut a notch out of the flare.
I did to mine. I wll try to find a pic.

Thanks for the pics crossfire, really helpful! It looks like all the pre-drilled holes are still there and line up and nothing but a trim is required.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top