Chevy and GMC Duramax Diesel Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
35 Posts
Discussion Starter #1
Does Anyone know what the stock ride height is in inches on a 2011 LML? I bought a used 2011 and I'd like to get to the original settings. I think the torsion bars may have been turned up but then again maybe not. Any way to know?
 

·
jokerfabworx.com
Joined
·
3,662 Posts
Does Anyone know what the stock ride height is in inches on a 2011 LML? I bought a used 2011 and I'd like to get to the original settings. I think the torsion bars may have been turned up but then again maybe not. Any way to know?
SRW or DRW?

Snow plow prep. or not?
 

·
Registered
Joined
·
2,583 Posts
I dont recall exact values but I do remember the back being exactly 3" higher than the front. That is on my CCSB 4x4
 

·
Registered
Joined
·
35 Posts
Discussion Starter #6
I had 40" to the front fender. 6 turns of the keys brought me down to 39". I'm thinking it might be too low now. Just looking for the factory setting.
 

·
Registered
Joined
·
2,583 Posts
Like I said measure the back then go 3" lower
 

·
Registered
Joined
·
385 Posts

·
Registered
Joined
·
35 Posts
Discussion Starter #9 (Edited)
Fender to fender or bumper to bumper?
They would be different. I just measured front fender to rear and set it at 3 inches. Hope that is right.
 

·
Premium Member
Joined
·
2,671 Posts
yep, but it was 39" in the back. it seems about normal compared to other trucks
 
1 - 14 of 14 Posts
Top