Chevy and GMC Duramax Diesel Forum banner
  • Hey Everyone! Enter your ride HERE to be a part of this months Ride of the Month Challenge!
1 - 1 of 1 Posts

·
Registered
Joined
·
7,883 Posts
Loosen the downpipe at the turbo so you can swing it if you will, pull the bolt that attaches the downpipe to the up pipe. Leave everything lose. It helps a ton. Take the bracket off the trans and put in exhaust and these how much bending it needs to get it to bolt back on. Once bolted in bend it back so the front pipe doesn’t sit in the cross member. Get everything where you want and like and start tightening everything up a little. I messed with mine (06) and a buddies 08 for a few hrs to get it just right. Then tighten the hell out of everything and drive it. Check it in a week or 2 and retighten everything. Mine has been solid for 8 years now and his for 4 years.


Sent from my iPhone using Tapatalk
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top