Chevy and GMC Duramax Diesel Forum banner
Cancel

New injector lines correct torque and still a crank case full of fuel!!

2353 Views 8 Replies 7 Participants Last post by  TxFullSize, 
ferdkila
Ok I had an 01' ecsb come in the other day pouring oil out of the crank vent. checked the balance rates with EFI and I got none of the balances were correct except one injector (-2). So i got Pensacola diesel to send me a set of remans and the install kit. I also bead blasted and cleaned the injector lines, flushed the fuel rails out and changed the fuel filter. Two days later the truck comes back with fuel in the crank case again! did the balance test again and everything check out fine there. So I tore into it thinking I didnt torque something down right (which I have forgotten to do once.) Re-torqued everything to specs re-assembled, changed the oil and drove it for about 20 miles. got back to the shop and pulled the dip stick only to find........... DIESEL IN THE OIL AGAIN!!!! Any idea guys?
Reply
Save
Like
1 - 1 of 9 Posts
rebpdt
looking at this --> "I also bead blasted and cleaned the injector lines" i'm betting another problem is your lines wont seal now. the abrasion from the blaster is just enough to cause them not to seal down well. a buddy of mine tried and got the same outcome.

get new lines from merchant auto - they have injectors too

that and you have pensacola injectors - dont use them EVER again
Reply
Save
Like
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Chevy and GMC Duramax Diesel Forum
A forum community dedicated to Chevy and GMC Duramax diesel owners and enthusiasts. Come join the discussion about modifications, towing, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Discussion 01-04.5 LB7 Duramax Powertrain Introductions Exterior Build Threads
Top