Chevy and GMC Duramax Diesel Forum banner
  • Hey Everyone! Enter your ride HERE to be a part of this months Ride of the Month Challenge!
1 - 3 of 3 Posts

·
Registered
Joined
·
716 Posts
Discussion Starter · #1 ·
Ok this truck is driving me nuts with the elevated idle at start up, I don't care that it doesn't need to warm up I'm going to no matter what, any way. Intake air heater comes on draws voltage trucks thinks it needs to idle up to charge faster. Disconnected grid heater and it starts fine even at the 27 we just had BUT it throws this p154b code which I can clear right off but I'm concerned that part of the code says ECM over voltage, really don't wanna fry an ECM any thoughts
 

·
Registered
Joined
·
716 Posts
Discussion Starter · #5 ·
I personally like to let a deisel sit and idle a few, besides who starts an engine of any kind and right away revs it up, but mainly I go to work at 4:30 in the morning and I start the truck to let it warm up a few minutes and almost every morning it elevates the idle, it just plain loud. My old lbz never did this, the volt meter would be low for the first 30-60 seconds and when the heater kicked off the voltage came up no problem
 

·
Registered
Joined
·
716 Posts
Discussion Starter · #8 ·
I know it's not the true elevated idle that's selectable, it's just the fact that twenty seconds after the truck is started it idles up to 950 and sits there till the voltage gets to around 12.5/13. My point is my old truck didn't do this to bump up charging output and had the iah on it and never had any issues with it. I just want to know if there is a way whether the iah is still hooked up or not to stop it from reving up every morning at 4:30am like a jackazz, I live in town now and I'm trying to be polite to my neighbors
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top