[DirtyMaxx03]

Im going from a single to dual exhaust. The problem is the crush clamps......they have crimped my shit together. Anyone know how i can get my muffler and tailpipe off? Un crimped??? Thanks

 

[Speedpro1]

Im going from a single to dual exhaust. The problem is the crush clamps......they have crimped my shit together. Anyone know how i can get my muffler and tailpipe off? Un crimped??? Thanks

Your going to have to heat them up and keep working it.

 

[DirtyMaxx03]

yeah i figured it would take some heat.....maybe a rubber mallet.

 

[setexan]

How is school going Sean?

 

[DirtyMaxx03]

Ummmmm...........................lets keep it on topic brian.


hahahahaha jk bud. its going good

 

[GeorgiaDuramax]

I would say a block a wood and a hammer

 

[Chevyguy08]

block of wood , hammer, wd-40 flat screw driver

 

[seth999]

I would use an air chisel and go around the seam expanding the outer pipe it should come right out...might have to use a small sharp chisel though to catch the seam

 

[seth999]

then like stated above there's always the wood and BFH method

 

[DirtyMaxx03]

i like the block of wood with a hammer idea.....more my style

 

[setexan]

Not get off topic again, Sean! But have you read your profile on here.

 

[DirtyMaxx03]

yes i have.....MOD POWA

 

[setexan]

I wasn't sure butt pirate was an occupation! I guess we have all kinds on this forum.

Your profile:

Biography:
Im a Stripper by day, And a Male Hooker by night!
Location:
Corpus Christi, TeXaS
Interests:
Big Strong Men!
Occupation:
Butt Pirate!

 

[jgs11]

Its a little expensive but it would do the job... Summit Racing SUM-900654 - Summit Racing® E-Z Pull Exhaust Pipe Separator Tools - Overview - SummitRacing.com