Chevy and GMC Duramax Diesel Forum banner
  • Hey Everyone! Enter your ride HERE to be a part of this months Ride of the Month Challenge!
1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I have a 2008 Duramax 4X4 Duramax with a 6inch pro comp lift which has 160,000+ miles on it, and was installed the year of the make. The steering is extremely loose, even though I have already replaced the UCAs, tie rods,and the ball joints are functioning properly. My buddy says I should go ahead and purchase all new steering linkages for it (I believe he means the stabilizer, Pittman and idler arms and new drop brackets.) However, I plan on lowering the keys nearly all the way down, and replacing the rear block to try to get to 4inches of lift. I have already purchased new shocks as well. How would the CV angles look? Also, what parts would work with this lift, and where would I purchase them? I would like to get parts that could hold up to the abuses of 4wd launches, if possible.

Thanks,
Dayton
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top