Chevy and GMC Duramax Diesel Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Just a stupid question but I am need of some guidance. Not sure if this is the right forum either, I am fairly new to This. I purchased a 2001 Chevy Silverado 2500hd 4wd with a rough country lift on it. I’m unsure of the lift size But I am wanting to return it to stock height. It’s Currently sitting on 35’s. What do I need to do/buy in order to return it to stock height? Any help would be appreciated.
 

· Registered
Joined
·
1,255 Posts
Thinking back to my installation years ago but, need the stock steering knuckles...shocks all around (may bottom out), upper control arms perhaps (lower should be stock). I remember though i had to cut something off to drop the front diff. this was on an 08 though. A 6" RC torsion drop lift.
If you have a level kit only its pretty easy . remove rear blocks if has them, and front just buy a set of stock torsion keys. Typically a level kit doesnt drop the diff.
 

· Registered
Joined
·
308 Posts
I have a 6.5" BDS lift and 35s in my 2014. That had to cut a cross member for the front diff. and as mentioned new UCA's, knuckles, etc., were installed. I spoke with BDS and they advised that I can drop truck down to a 4" height just by using the keys.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top