Chevy and GMC Duramax Diesel Forum banner

Transgo Jr

1497 Views 8 Replies 7 Participants Last post by  Durallymax
I know Ive seen it on here b4 but cant seem to find it again but does anybody know what bolts if any need to be torqued and to what specs when reassembling transmission after installing Trango Jr???
1 - 9 of 9 Posts
Torque specs are 8 to 10 ft-lbs. I did mine at 8, it is plenty enough to hold it. Keep the tranny clean as possible and do not let any debris in. Read the instructions very carefully and double check, even better check it as many times you can to ensure it is correct.
Check your PM's I sent you an install article.
Check your PM's I sent you an install article.
Could you send it to me? :D



its the valve body bolts that matter not the pan bolts
If they have not fixed the directions yet there is an error. There are only 5 o-rings not 6. You will know what I am talking about when you get in there.
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top